View Gardening .com

What exactally do you mean 'breaking' - like the fins break off, or its a new flywheel each time. Think of the flywheel as a balancer/alternator - the flywheel is part of the unit that makes spark to run the tractor, it also balances the motor. If bits are breaking off a single flywheel, remove it and get another one. Theyre made of cast iron, it'll keep breaking till it shatters and carves its way thru the flywheel shoud and possibly into a body part. Dont keep running it like that, if you value breathing.

2007-08-25 15:43:02 by balletlover

My newest kijiji pickups just showing and un loading.

had put in a new battery

You don't provide much information. Does the engine turn over and not start, does it not turn over? There are several things that will prevent it from starting but we need more information.

2007-04-29 10:46:53 by juana1

Price: $24.76 $9.03

Length: 19-11/16-inches
58190
Need 2 for 39" cut

I have a Dynamark Lawn Mower that i am modifying to make it fast. Not planning to race it anywhere, just a small engine project at school and something to mess around with. Im stuck with pulling off the front pully. I do not really know how to pull that one off. I pulled the back on off with my hands but the front one is causing me an issue. any ideas? i tried using a puller but i dont think its the right kind and i dont know how well it will really work. Just looking for some suggestions.

While im asking a question, any cheap and easy fixes to strengthen the front end so i dont have to worry about it flying about going 50? All serious answers would be greatly appreciated.

Thankz!
I would like to provide you with more details, but i do not know too many details myself. I just got this mower from my girlfriends dad randomly and do not know anything

The front pulley has a bolt in the end of the pulley. Remove it with a socket and ratchet. You can make the tractor more stable my limiting the travel of the front axle at the pivot point where the axle is bolted to the frame. A smaller pulley at the transmission will make it faster.

2009-03-12 11:50:13 by Robinson

Price: $24.03 $13.10

316608/313954
Need 2 for 42" cut
Length: 21-9/16-inches

...I have a Dynamark push lawn mower (Made by Murray, I THINK!) with a 4.75 hp briggs & Stratton engine-it has no throttle, and is set so low it barely keeps from stalling even in short grass. To you small engine experts out there-how do I increase the rpms, or increase throttle speed?? Note- there are no wires or lines of any kind that appear to go to the carb- the only wire cable is the cut off one (For if you let go of the handle, the mowere stops automatically!) HELP!!!

It has a governor that keeps the engine running at the designed speed. Do not adjust it unless you know what you're doing! If it's set correctly, and you turn it up, it'll run the engine faster than it's designed to run, which will wear it out very quickly. The governors are very reliable and it's not likely it's working incorrectly unless it's been damaged in some way.

Are you sure it's not running fast enough? Is it possible that it's running at the correct speed, but slowing down as soon as the blade hits some grass, as if it has no power? If that's the case, your blade is dull as a table knife (duller, actually).

They have to be sharpened at least occasionally. You can take it to a shop and have them do it, or you can do it yourself with a small file or an angle grinder. If you do it yourself, REMOVE THE SPARK PLUG CABLE before you get near the blade so it can't start when the blade moves.

2007-09-25 13:24:47 by mrtrucker